http://www.hybertone.com
SIP Phone EP-8201
LAN Port Configuration
The VoIP Phone LAN port can be configured to obtain its IP address by DHCP or the IP
address can be set statically (used mainly when using the phone with a DSL line).
If you obtain a static IP address from your ISP, you can assign it to the VoIP Phone LAN
port by choosing
“
Static IP
”
selection and then entering the fields as provided.
1.
Enter IP address of the phone beside
IP Address
.
2.
Enter subnet mask beside
Subnet Mask
to specify the LAN Netmask.
3.
Enter IP address of the default router beside
Default Route
.
4.
Enter Primary and Secondary DNS addresses.
PC Port Configuration
Bridge Mode
is the recommended setting for the VoIP Phone. This configuration is
important for an environment with an existing LAN and only one Ethernet outlet. It allows
a computer connected to the PC port to access the existing LAN. There is no need to
reconfigure the PC or the existing LAN.
In addition, the PC port also offers a Static IP mode which enables a new network segment
to be setup. A DHCP server can also be enabled to facilitate IP address assignment and
management.
Setting the Time Server and Time Zone
The Time Server is the Network Time Protocol server where the VoIP Phone retrieves date
and time information. The time is in GMT
±
offset. For example, Pacific Standard Time is
GMT -8, and Pacific Daylight Time is GMT -7.
To set the Time Server and the time zone:
1.
At the
Time Server
field, enter the IP address or the domain name (FQDN) of a valid
Time Server entry. It is set to timekeeper.isi.edu as factory default.
2.
At the
Time Zone
field, enter GMT+x where x is the time difference between your
time zone and GMT.
Performing an Online Upgrade
WARNING!
Performing an online upgrade is for experienced users or administrators only!
To prepare the VoIP Phone for an online upgrade:
1.
Click
Tools
and then
Online Upgrade
.
2.
Enter the IP address or domain name of the upgrade server and package name (ex.
http://wwwhybertone.com/update/cn2x4-3_08_14_15.pkg
).
3.
Click
Start
.
4.
The message below appears when the firmware upgrade is completed. Click
OK
to
continue.
“
Upgrade successful!
”
