9
rack which should be between 12.5V* and 30V DC with wiring sufficient to carry up to 5A at 12
volts. If these parameters are not met the K8 will not charge correctly if at all. If the supply is poor
you may see/hear random red status LED flashes and beeps from the K8. The supply must be
rectified to prevent non charging of the K8 and possible damage to the unit.
*To initiate charging, the K8 must see a voltage of 12.5v DC approx, once started the voltage
can be allowed to fall to around 12v, below this the unit will stop charging to preserve the
supplying battery, e.g for vehicle starting etc.
b) Check the 5A fuse in the cigar lighter plug by unscrewing the end cap of the plug and removing
the fuse to view whether it’s blown or not (Note – take care not to lose the spring and other small
parts). If blown, locate the source of the problem, replace the fuse and try again.
c) Check the cigar plug connection is good with the socket it is connected to.
d) Check the docking charge rack terminals haven’t been damaged through misuse. They should
spring back against the front of the charge rack. To check, remove the K8 from the rack, press the
blue buttons on the front face then release them, the two spring terminals should sit up against
the grey front of the rack.
Contact Hy-Ram Engineering Co. Ltd on 01623 422982 for technical assistance
or e-mail [email protected].
CONFORMANCE
CE Marked. This product has been tested and conforms to EN 61000-6-3 and EN 61000-6-4.
IP54 Rated - Protected against dust with limited ingress, and against water spray from all
directions.
OPTIONAL REMOTE CONTROL
Contains Transmitter Module FCC ID: OA3MRF24J40MA
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.
