8
MAINTENANCE
Your K8 LED should need little or no maintenance during its life span other than periodic cleaning
of the exterior surfaces, when we suggest using a light detergent and water to sponge off any
dirt deposits. Should you encounter a problem then please contact Hy-Ram Engineering Co. Ltd
for technical assistance. We suggest the unit be returned to us for any problems that can’t be
rectified by telephone. Please note there are no user serviceable parts inside and that a competent
person must carry out any repairs.
RECYCLING AND THE ENVIRONMENT
Your K8 LED contains various parts that need to be recycled at the end of its life span, please
contact your original point of purchase for information on correct recycling of this product to help
protect the environment.
TROUBLESHOOTING
1. Light doesn’t power up when the on button is depressed:
a) Is the blue status LED next to the On/Off switch blinking when the unit is neither on charge or
switched on? If not, there is no power in the battery – place the K8 on charge and fully recharge
the battery.
b) Is the battery charged up? Recharge the battery fully so the charging status LED has cycled
through to flashing green. If there is still no blue LED blinking once the K8 is taken off charge then
the unit should be returned to point of purchase for investigation.
c) Does the status LED function as normal? If the status LED alternates between green and amber
rapidly when attempting to switch the K8 on this signifies a failure of the main light engine LED(s)
or a break in one of the cables supplying them. The K8 must be returned to point of purchase for
investigation.
2. Poor run time or no operation at all:
a) Has the battery been left completely flat for an extended period of time? Depending on the
battery chemistry (Sealed Lead Acid or Lithium Ion) employed within the K8, will determine how
well the unit recovers from being left in a deep discharged state. If the light still doesn’t operate
after an attempt at fully recharging, or the duration the light runs for before shutting down is
significantly reduced from the original specification, then the K8 will need to be returned to point
of purchase to have a new battery fitted.
3. No charge indication:
a) The K8 status LED should indicate red, amber or green and you should hear a double beep
when the K8 is placed on charge. If neither happens then check the supply to the docking charge
