Select the base assembly (Item No. 4) and the
#16 compression clamp (Item No. 8) Slip it
on the end of the base assembly. Do
not
tighten at this time.
Installation of the Tubing Clamps
Take care when measuring the tubing lengths
for your mode of transmission.
Select the proper size tubing clamp as shown
in the chart. When installing the clamps, place
the clamp near the tube end with the top of the
clamp over the slot in the tube as shown in
Figure 2.
After adjustment of the tubing lengths, tighten
the clamp with a 5/16 inch nut driver, socket,
or open end wrench until the tubing will not
twist or telescope.
Figure 2 Tubing
Clamps
