Hy-Gain AV-12AVQ, Инструкция по эксплуатации

Страница: 4 / 20

Select the M2 section (Item 1) and slip it into
the base assembly. Measure Dimension 'Was
shown in Figure 3 according to your mounting
location and mode of transmission. Now
tighten the compression clamp
slightly.
Carefully recheck all dimensions - then
tighten all compression clamps
securely.
Place the 7/16" caplug (Item 10) on the end of
the antenna.
Select the #10 tubing clamp (Item 9) as shown
in Figure 2. Slip the clamp over the M2
section but do
not tighten as this time.
Install the two (2) U-bolts (Item 13) using the
5/16" nuts and lockwashers (Items 16 and 19)
as shown in Figure 4.
Select the 10-meter trap (Item 5) and slip it
into the M2 section with the plastic cap at the
top. Measure 2 1/4 inches from the edge of the
M2 section to the bottom of the trap as shown
in the illustration (Dimension "B"). Now
tighten the clamp
slightly.
Select the M3 section (Item 2) and a #10
tubing clamp and slip it onto the M3 section.
Now slip the M3 section (end with clamp
installed) over the 10-meter trap and measure
Dimension "C" according to your mounting
location and mode of transmission. Tighten
compression clamp
slightly.
Select the four (4) 1/4"-20 x 3/4" screws, nuts
and lockwashers (Items 12, 17 and 20) and in-
stall on the base assembly. If the antenna is to
be ground mounted, tighten these screws
securely. If the antenna is to be roof mounted,
refer to Figure 5 before tightening these
screws.
A radial system must be added for
proper operation when this antenna is mounted
on the roof.
This radial
s y s t e m
can also
a c t a s
t h e
guying
s y s -
tem. The radials should be the
length shown in Figure 6 after the strain
insulators are installed. If you prefer, you may
obtain a radial system specifically designed
for your 12AVQ-S by asking your local Hy-
Gain dealer for the 14RMQ.
Select the remaining #10 tubing clamp and
slip it over the M3 section.
Select the 15-meter trap (Item 6) and slip it
into the M3 section with the plastic cap at the
top. Measure Dimension "D" according to
your mounting location and mode of
transmission. Tighten compression clamp
slightly.
Select the #6 tubing clamp (Item 7) and slip it
over the 1 5-meter trap.
Select the M4 section (Item 3) and slip it into
the 15-meter trap. Measure Dimension "E" ac-
cording to your mounting location and mode
of transmission then tighten the compression
clamp slightly.
CAUTION
If copper is used for the radials, solder lugs must be used
to prevent dissimilar metal corrosion from occuring.