HWAM 3130, Руководство пользователя

Страница: 20 / 44

20
Place two pieces of wood (5-8 cm in diameter) horizontally in the bottom of the
combustion compartment. Place 5-8 pieces of kindling randomly on top. Place
two fire-lighters in between the top layers of kindling. Press the remote control
twice to activate the symbol of lighting up. Light up the fire-lighters and close
the stove door. Adjust the temperature selection mechanism on the remote
control to the desired heat level.
If the desired flue gas temperature of 350° C has not been achieved within 15 minutes, the remote
control will activate a re-stoking alarm even if there still might be wood and flames in the combustion
compartment. The re-stoking alarm can seem misplaced, but it is activated because the temperature
climbs too slowly. Re-stoking with small pieces of kindling wood can often result in a faster increase
in temperature.
HWAM Autopilot IHS TM closes all three air dampers when the stove is in standby mode. This prevents
hot air from the room to enter the chimney (heat loss). This might on the other hand result in a very
cold chimney when the stove is lit. In certain cases it is necessary to assist the draught in the chimney
by burning a couple of newspaper pages on top of the wood ready to be lit. Read more on www.hwam.
com about the function of the chimney.
Important!
The ashpan must not be opened when lighting up. It must always be closed when the stove is in use.
Otherwise the stove’s intelligent control system does not function. The door should only be opened
when lighting up, when restoking, and when cleaning the stove.
The Thermostat Function
The HWAM Autopilot IHS
TM
will in general have an environmentally friendly combustion and adapt
to the desired room temperature. The thermostat function is designed as a radiator valve. The user
enters a desired heat level, which suits the room in which the stove is installed. When the thermostat
is set at a heat level, the control function will adapt to this temperature.
• If the room temperature is lower than the desired heat level, the control function increases the flue
gas temperature in order to increase the heat radiation from the stove.
• If the room temperature is higher than the desired heat level, the control function decreases the
flue gas temperature, thereby giving the layer of embers as long a life as possible before re-stoking.
This will reduce the heat radiation from the stove and facilitate re-stoking without having to light
up the fire anew. If the room temperature drops below the desired level, the ember phase will be
shortened, and the system will activate a re-stoking alarm. The system will signal that a re-stoking
is due at the flue gas temperature of 180° C, and at 100° C the system will enter standby mode and
all dampers will close.
• Should the room temperature be much lower than the desired heat level, the control function
increases the flue gas temperature. If a satisfactory increase in temperature does not occur, the
control will activate a re-stoking alarm, since it expects that more wood is needed to increase the
heat level in the room.
• If the room temperature after a new re-stoking still does not reach the desired level, the water
content in the firewood may be too high or the draught in the chimney too weak. For environmental
reasons the recommended flue gas temperature should always be a min. of 350° C.
Stoking
When the stoking alarm on the remote control sounds, the stove is ready for stoking. The remote
control will recommend the amount of wood you should use.