HW Group Poseidon 2250, Краткое руководство

Страница: 18 / 54

Poseidon 2250 – Short Manual HW group
www.HW-group.com 18 / 54
Detailed device description
Power connector
The usual DC plug – 2,5mm coaxial barrel
connector – is used to connect the power.
Negative terminal is connected to the outer body of the plug.
Ethernet
Ethernet network connects via the standard RJ45 jack next to the power
connector. Use a Twisted Pair (TP) patch cable to connect to a switch, or a
cross-over cable to connect directly to a PC.
The device has a 10 Mbps Ethernet interface => it only works in
10 Mbps or 10/100 Mbps networks.
Note: The device cannot be directly connected to a 100 Mbps-only network. If you need to
connect it to a 100 Mbps (or faster) network, use a 10/100 Mbps Ethernet switch.
MAC address
MAC address is a unique number identifying the device. It is printed on the label at the bottom side of
the unit. It consists of six hexadecimal number pairs, the first three pairs are always
00:0A:59 .
With the MAC address, you can distinguish individual devices in the UDP setup utility when assigning
IP addresses.
Configuration with DIP switches
DIP switches control the following functions. If you
change the settings, it is recommended to reset the
device by disconnecting and reconnecting the power.
Factory default configuration is:
DIP1=Off, DIP2=Off, DIP3=Off, DIP4=Off.
DIP SWITCH configuration
+ DIP1 – RS-232 Setup
ON = RS-232 Setup mode (RS-232 mode only), OFF = Normal mode, network active
LOAD DEFAULTS : Toggle the switch 3 times within 5 seconds after powering up.
+ DIP2 Not used
+ DIP3 – Security
ON = Secure mode (HW protection) – no configuration changes possible
OFF = Unsecure mode – configuration not protected by HW
+ DIP4 – RS-485 Echo ON = RS-485 bus Echo mode – communication forwarded to the RS-232 port