HW Group Poseidon 2250, Краткое руководство

Страница: 16 / 54

Poseidon 2250 – Short Manual HW group
www.HW-group.com 16 / 54
Ethernet port
+ Interface
RJ45 (10BASE-T) – 10 Mbit/s
Compatible with 10/100 Mbit/s networks
+ Supported protocols IP: ARP, TCP/IP (HTTP, Modbus over TCP), UDP/IP
+ SNMP compatibility Version 1.00 compatible, partial version 2.0 implementation
Port 1 – RJ12 – 1-Wire bus (Dallas Microlan)
+ Type HWg original accessories: 1-Wire or 1-Wire UNI
+ Connector
RJ11 (1-Wire Bus)
+ Sensors / distance Max. 10 sensors, up to 20m (single sensor) or 10m in total (star topology)
Port 2 – RJ45 – Industrial Bus (RS-485)
+ Connector RJ45 (8 pins)
+ Sensors / distance Max. 31 sensors, up to 1000m
+ Bus termination Internal termination in Poseidon (place Poseidon to beginning or the end of the bus)
+ Supplied power 12V / max 120 mA – Max 4 external RS-485 sensors without external power
Port 3 – DB9M – RS-232
+ Connector D-sub 9-pin male connector (DB9M)
+ Pinout IBM PC standard (RxD, TxD, RTS, CTS, DTR, DSR, GND)
+ Usage Serial Setup, extra pins
+ Sensors
No sensors support
+ GSM modem Supported, require special cable (Rxd, TxD and GND only)
+ Outputs 2 additional outputs (1/0): RTS(+10V/-10V), DTR(+10V/0V)
Port 4 – Dry Contact Inputs
+ Contact inputs 3 digital inputs, accept NO/NC dry contacts
+ Input type One common pin, all inputs opto-coupled, max. distance 30m, logic H = 0…500 Ω
LED Status indicators
+ POWER Green – Power OK
+ LINK & Activity Green – Ethernet connectivity
+ SENSOR RS-485
Yellow slow – No RS-485 sensors found
Yellow fast – RS-485 sensors read, value valid
+ MODE & RS-232
Red – Device is in the RS-232 Setup mode
Red lit – One or more sensors out of the defined Safe Range
Green – fast once – Sensor reading, value valid
DIP SWITCH
configuration
+ DIP1 – RS-232 Setup ON = RS-232 Setup mode (RS-232 mode only), OFF = Normal mode, network active
+ DIP2 Not used
+ DIP3 – Security
ON = Secure mode (HW protection) – no configuration changes possible
OFF = Unsecure mode – configuration not protected by HW
+ DIP4 – RS-485 Echo ON = RS-485 bus Echo mode – communication forwarded to the RS-232 port
Physical
+ Supply voltage
12VDC / 250 mA (Min 9V, Max 25V)
cylindrical (barrel) power connector, GND on the shielding
+ Dimensions 25 x 82 x 90 [mm] (H x W x D )
+ Weight 450 g
+ Temperature range
Operating: -10 to 60 °C / Storage: -25 to 85 °C
+ MTBF > 80 000 hours