HW Group Poseidon 2250, Краткое руководство

Страница: 19 / 54

Poseidon 2250 – Short Manual HW group
www.HW-group.com 19 / 54
POWER (green)
LINK (green)
SENSOR (yellow)
MODE (red/green)
Port 1 RJ45 Port 2 RJ12 Port 3 DB9M
DIP1 - RS-232 Setup mode
DIP1 activates the RS-232 Setup mode. If DIP1=ON when the device is powered up, the RS-232
Setup mode is activated and the red MODE LED blinks. The Ethernet is disabled in this mode!
To restore factory default settings: Toggle the DIP switch at least 3 times within 5 seconds
after powering up the device.
DIP3 – HW security protection
When DIP3=ON , the HW-Security protection mode is active. Any configuration changes are
ignored in this mode:
No settings can be changed with UDP Setup (using UDP Config or Herkules utilities)
Flash Setup still opens in the browser but no settings can be changed
TCP Setup (at port 99 by default) is not available
No parameters can be changed over SNMP
LED indicators
LEDs indicate the current mode, power being supplied,
Ethernet activity and sensors being read.
POWER (green)
Indicates that the power supply is on.
LINK (green)
Indicates that the Ethernet connection is
functional.
SENSOR RS-485 (yellow)
Quick flashing indicates that a valid value has
been received over the RS-485 bus.
Slow flashing means that some sensors on the RS-485 bus were not found.
MODE & RS-232 (red/green)
Red slowly flashing – Device is in the RS-232 Setup mode = Ethernet is disabled (check
DIP1).
Red continuously on – At least one sensor or input is in alarm.
Problem LED indication
Ethernet disconnected Green LED (LINK) turns off
RS-485 sensor torn off (alarm inactive) Yellow LED (SENSOR) blinks slowly
RS-485 sensor torn off (alarm active) Red LED (MODE) is on
IT bus sensor torn off (alarm active) Red LED (MODE) is on