Ares LTE
14
Outputs
It is possible to connect the External Outputs module via the 1-Wire UNI interface to the Ares 12
LTE device. This module provides 4 NO/NC relay outputs with maximum load up to 1 A / 30 V DC
or up to 0,5 A / 50 V AC.
•
State
– graphical information of inputs status - identical as on the
General
tab.
•
ID
– unique ID of the sensor.
•
Name
– input name for its easier identification and for the needs its processing within superior
systems.
•
Value
– current input status:
•
0
– disconnected (power Off).
•
1
– connected (power On).
•
Name (0)
– disconnected input status name (Off, open).
•
Name (1)
– connected input status name (On, closed).
•
Serial Code
– unique 1-Wire ID.
•
Condition
– output control method.
•
Manual & Remote
– controlling the input manually by the
SET
switch (Set 1 – switch On,
Set 0 – switch Off) or by M2M protocols.
•
On if any alarm
– the output switches On when at least one of the inputs or sensors is in
alarm status. Note that this condition reflects the DELAY and HYSTERESIS settings for indi-
vidual active inputs and sensors.
•
On if alarm on
– the output switches On when there is alarm on a defined input or sensor.
•
On if value equal to Trigger
– the output switches On when the measured value matches the
Trigger Value
setting.
•
On if value higher than Trigger
– the output switches On when the
Current Value
exceeds the
Trigger Value
setting.
•
Trigger Value
– the trigger value of a condition (for example: the output switches to On when
a current value exceeds the
Trigger Value
).
•
Dependent On
– selection of the input or sensor to which the condition is applied.
•
Find Outputs
– detects external outputs module. By default, outputs are detected only when the
unit is powered up. Later connected outputs must be detected manually. Detected outputs are
automatically added to the list.
Advanced settings
Содержание Ares 10 LTE
Страница 1: ...Ares 10 12 LTE User manual...
