11
panel B3. the load power can not exceed the maximum output power of the
machine.
4. Close the external blade, and turn on the machine power switch A7, the
displays of A1, A2, A3 also should be light.
5. Adjust the output voltage button A10 to the designed value after power on
for half a minute.Get the output voltage from U, V, M, N phases, among witch
A3 dispalys the voltage of U, W phases, A2 displays the load current of V
phase.
6. Adjust the rough tune button to the approximate designed phase shift angle,
then adjust the fine tune button A11 with the selection switch A9(when the
switch is up, adjust A11 clockwisely for one loop and the phase shift is 15°
；
when the switch is down, adjust A11 Counterclockwisely for one loop and the
phase shift is 15°).After adjustting A4 button,turn the selection swith A9 to the
top and turn the button A11 clockwisely, then the display of phase shift
increases.One scale of rough tune includes fine tune range from 0°~30°, and
the A1 displays the phase shift angle with the reset button A5.After adjusted to
the designed angle,press latch button A6 to lock the number of A1.Also, Press
A5 again to get a new phase shift angle.
Ⅵ
.NOTES
1. It is not allowed to connect the output point N to input zero line.
2.The machine is on the work with strong power, so it is necessary that ground
