Huvema HU 30 CROSS-4, Руководство пользователя

Страница: 8 / 22

(1) When milling longitudinal feed.It is advisable to lock the cross feed
table travel to insure the accuracy of your work. To do this , tighten the
small leaf screw located on the right side of the table base.
(2) To tighten the longitudinal feed travel of the table for cross feed
milling,tighten the two small leaf screw on the front of the table base.
(3) Adjustable travel stops are provide on the front of the table for control
of cross travel and the desired milling length.
TO CHANGE TOOLS
(1) Removing Face Mill or Drill Chuck Arbor
Loosen the arbor bolt at the top of the spindle shaft approximately 2
turns with a wrench.Rpa the top of the arbor bolt with a mallet.
After taper has been broken loose,holding chuck arbor on hand and turn
detach the arbor bolt with the other hand.
(2) To install Face Mill or Cutter Arbor
Insert cutter and cutter arbor bolt detach securely, but do not
over-tighten.
(3) Removing Taper Drills
(a)Turn down the arbor bolt and insert the taper drill into the spindle
shaft.
(b)Turn the rapid down handle rod down until the oblong hole in the
rack sleeve appears.Line up this hole with the hole in the spindle.Insert key
punch key through holes and strike lightly with a mallet. This will force the
taper drill out.
SPECIFICATION OF T-SLOT
The size of T-Solt on table as fig.4