Huvema BL 50 AIR, Руководство пользователя

Страница: 5 / 14

5
CHANGES AND T YPING ERRORS RESERVED CHANGES AND T YPING ERRORS RESERVED
6. a
ssembly
Note : Before performing any assembly or maintenance make
compressor be turned off and unplugged from the power supply.
6.1 i
nsTallinG The wheels
1. Locate the wheels, hex bolts, washers, and wheel nuts.
2. Insert hex bolt through wheel rim and wheel bracket in place located on the bottom rear of the air
compressor.
3. Slide washer on the end of bolt.Securely tighten bolts and wheel nuts in place with a wrench.
4. Repeat step 2 to 3 for remaining wheel. (fig 1)
Fig 1
6.2 i
nsTallinG The
o
il and
o
il
b
reaTher
Before you starting the air compressor please remove the white oil stopper and add oil into crankcase.
Before starting the air compressor you must verify oil the crankcase and install the oil breather as described
below:
1. Place compressor on level ground.
2. Remove the Plastic Oil Stopper the Oil Fill Hole.
3. Verify oil in the Crankcase.lf the oil level down to the center of the red dot on the oil Sight Glass, slowly pour
the oil into the Oil Fill Hole until the oil level rises to the red dot.
4. Insert the Oil Breather into the Oil Fill Hole. Firmly hand tighten the Oil Breather by turning clockwise.
Note:
This compressor uses only SAE20 or SAE30 non-detergent motor oil. (See Figure2.1-2.2)
Figure 2.1 Figure 2.2
6.3 i
nsTallinG The
a
ir
f
ilTer
The Air Filter is installed into the threaded port of the Cylinder Head.
1. Thread the Air Filter into the Cylinder Head by turning the Air Filter clockwise.
2. Securely tighten the Air Filter in place with a wrench.
Note
: DO NOT over tighten Air Filter.