Huvema BL 50 AIR, Руководство пользователя

Страница: 7 / 14

7
CHANGES AND T YPING ERRORS RESERVED CHANGES AND T YPING ERRORS RESERVED
Your Air Compressor is equipped with an air pressure requlator. This regulator adjust the air pressure.
To increase Air Pressure, turn Air Regulator clockwise.
To decrease air pressure, turn Air Regulator counterclockwise.
8. m
ainTenance
DAILY (or before each use)
l. Check oil level
2. Drain condensation from the Air Tank.
3. Check for any unusual noise or vibration.
4. Be sure all nuts and bolts are tight.
8.1 w
eekly
Clean breather hole on oil breather.
8.2 m
onThly
Inspect air system for leaks by applying
Tighten these joints if leaks are discovered.
or after 250hourse of operation-whichever comes first)
Change air compressor oil.
Note : Change oil more often if air compressor is used near paint
spraying operations or in dusty environments.
8.3 c
heckinG The
a
ir
c
ompressor
o
il
1. Place Air Compressor on level surface. The oil level should be at
the red dot on the Oil Sight Glass.
2. If oil level is low, remove Oil Breather and add enough oil to
bring the oil level to the red dot on the Oil Sight Glass.
3. Replace Oil Breather before starting compressor.
8.4 c
hanGinG The
a
ir
c
ompressor
o
il
1. Remove the Oil Sight Glass by tuming counter clockwise with wrench.
Note : Oil will begin to drain as Oil Sight Glass is loosened.Place a funnel and oil pan in place before
loosening Oil Sight Glass.
2. Once Oil Sight Glass is removed, tilt Air Compressor backwards to allow all of the oil to drain out of the
crankcase.
3. Once oil is drained, replace Oil Sight Glass and securely tighten in place with a wrench. Be careful not to over
tighten the Oil Sight Glass, this will damage the rubber seal.
4. Place Air Compressor on level surface.
5. Remove the Oil Breather.
6. Slowly pour the oil into Oil Fill Hole, untill the oil level rises to the center of the red dot on the Oil Sight Glass.
7. Install the Oil Breather into the Oil Fill Hole. Firmly hand tight the Oil Breather by turning clockwise.
Always inspect the tool before use, and make sure it is in good working condition. Make sure all air vents are clear,
(use compressed air to clean the machine if possible). Check the power cable to make sure it is intact and free
from cracks, bare wires etc. To avoid using solvents when cleaning plastic parts, most plastic are susceptible to
damage from the various types of commercial solvents.