HUSTLER TrimStar 927632, Руководство пользователя, Страница: 25 / 33

close to the handle grips. Shorten the effective length
of the brake rod to increase braking.
3. Check air pressure in drive wheels (12 psi). This is
critical for appropriate mower tracking.
4. Check for proper belt tension (see belt tension guide).
Keep a 1/8" to 1/4" clearance between belt guides and
belts. Be sure the drive control rod is properly
adjusted in the thumb latch. (See Fig 5-1.)
5. After a 10 hour “Break-In” period go through steps 1
thru 4.
6. Proper adjustments must be maintained to insure safe,
trouble free, long life operation of the mower. After
completing the foregoing instructions and
recommended procedures you are ready to put the
mower into operation.
Belt tension guide
Belt Inch Deflection How to Adjust
Engine to Deck . . . . . . . .1/2" . . . . . . .Turnbuckle at Idler
Engine to Transmission . .1/2" . . . . . . .Sliding Idler
Secondary Deck
Drive Belt (48") . . . . .1/2" . . . . . .Threaded Rod to Idler
Wheel Drive . . . . . . . . . .1/2" . . . . . . .Self-Adjusting
WARNING: Excessive belt tension may cause
damage.
Engine RPM setting
The TrimStar is designed so that the engine will run at
3600 rpm static transmission load only.
ADJUSTMENTS
Introduction
WARNING:
Unless specifically required, DO
NOT have engine running when servicing or
making adjustments to unit. Place transmission
handle in the neutral position, disengage blade
engage lever, place thumb lock levers in the park
brake position, and remove ignition switch key.
Repairs or maintenance requiring engine power
should be performed by trained personnel only.
To prevent carbon monoxide poisoning, be sure
proper ventilation is available when engine must
be operated in an enclosed area. Read and
observe safety warnings in front of manual.
Your TrimStar was adjusted before it left the factory and
was checked during predelivery setup. However, after start-
up and continued use, a certain amount of break-in wear
will cause some adjustments to change.
Remain alert for unusual noises, they could be signaling
a problem. Visually inspect the machine for any abnormal
wear or damage. A good time to detect potential problems
is while performing scheduled maintenance service.
Correcting the problem as quickly as possible is the best
insurance.
WARNING:
Keep your machine clean and
remove heavy deposits of trash and clippings,
they can cause engine fires as well as excessive
belt wear.
Clear away heavy build-up of grease, oil and dirt,
especially in the area of engine oil and engine combustion
air; minute dust particle are abrasive to close-tolerance
engine assemblies.
Some repairs require the assistance of a trained service
mechanic and should not be attempted by unskilled
personnel. Consult your Hustler service center when
assistance is needed.
Torque values
Torque values given below:
Ft-lbs. Nm
Blade spindle nut (top) ............90 .................122
Blade spindle bolt (bottom) ...118 .................160
For engine torque values, see engine owner’s manual.
For all other torques refer to the parts manual for
standard torque chart.
Neutral lock adjustment
1. Park the unit on a level surface and shut off engine.
Disconnect the spark plug wire from the spark plug.
2.
Adjust the brake control rod to obtain “free wheeling”
with the drive levers in the neutral position and
positive braking when the drive levers are squeezed
5-1 102780 6/05
Neutral Neutral
Lock
Lock
Park Park
Position
Position
Drive-Rod Drive-Rod
1/4" - 3/8" 1/4" - 3/8"
Figure 5-1
Thumb Latch