HUSTLER TrimStar 927632, Руководство пользователя, Страница: 23 / 33

Mower blade removal
Use a 15/16" wrench to remove the 5/8" cap screw
holding blade to spindle saddle from underneath.
Sharpen the blades on a grinder following pattern as
shown (Fig. 4-10). Touch-up sharpening can be done with
a file.
Check the blades for balance following grinding. A
commercial balancing tool is available through most
hardware supply stores, or balancing can be done by placing
the blade on an inverted line punch or 5/8" bolt. Blade
should not lean or tilt. Spin the blade slowly, blade should
not wobble. If blade is out of balance, true it up before
reinstalling.
Lay the blade on a flat surface and check for distortion
(Fig. 4-11 and 4-12). Replace any distorted blade.
Do not re-use spindle bolts which have stripped, worn or
undercut threads. Torque bolts to 118 foot-pounds when
reinstalling blades.
WARNING:
When mounting blades, rotate
them after installation to ensure blade tips do not
touch each other or sides of the mower.
WARNING:
Failure to correctly torque the bolt
may result in the loss of the blade which can
cause serious injury.
48” Deck
Figure 4-7
1
5
3
2
5
4
4
1
2
5
4
4
32”/36” Deck
102780 6/05 4-5
Figure 4-8
1. Traction drive pulley
2. Idler pulley
3. Traction drive belt
4. Wheell pulley
1
2
3
4
1. Engine pulley
2. Deck drive belt
3. Deck spindle belt
4. Spindle pulley
5. Idler pulley
1
3
2
4
1. Engine pulley
2. Transmission drive belt
3. Transmission pulley
4. Idler pulley
Figure 4-9
Figure 4-10
Resharpening Pattern
Do not sharpen to original pattern (below).
It is easier to get a straight cutting edge following
the resharpening pattern shown above.
Original Edge