HUSTLER ATZ, Руководство оператора, Страница: 31 / 48

604243 4-3 REV C
Master in-line fuse
These mowers have a master in-line fuse in the electrical
system. This is the main fuse to protect the complete electrical
system. It is located at the left front of the engine close to the
starter. Figure 4-2
Hydraulic System
IMPORTANT:
Never use hydraulic or automatic transmis-
sion fluid in this system; use only motor oil as specified.
Remember, dirt is the primary enemy of any hydraulic system.
Check oil level in hydraulic system after every 50 hours of
operation or weekly, whichever occurs first. Check more often if
system appears to be leaking or otherwise malfunctioning.
Figure 4-3
Fluid level should be 1” (2.54cm) from top of reservoir. Use
only 15W50 Mobil One oil in the Hustler ® ATZ.
NOTE: The reservoir will require approximately 3 U.S. gal-
lons (11.35 liter) of 15W50 Mobil One oil when replacing the
oil after an oil and filter change. Do not overfill the reservoir.
Change hydraulic system filter element and oil after first 50
hours of mower operation, then replace filter and oil in reservoir
every 500 hours thereafter.
IMPORTANT: It is necessary to drain the system oil from
the hydraulic reservoir, using the reservoir drain plug, before
removing the hydraulic filter. Replace the drain plug before add-
ing system oil.
The Hustler ® ATZ system filter is located inside the hydraulic
reservoir on the underneath side of the tank. Use a Hustler ®
• Always wear eye protection when checking the bat-
tery, acid can cause serious injury to skin and eyes.
If contact occurs, flush area with clean water and
call physician immediately. Acid will also damage
clothing.
• Do not drink the battery electrolyte.
• Do not allow open flame near the battery when
charging.
• Hydrogen gas forms inside the battery. This gas is
both toxic and flammable and may cause an explo-
sion if exposed to flame. Always remove the nega-
tive ground first and replace it last.
• Do not overfill battery.
• Electrolyte may overflow and damage paint, wiring
or structure. When cleaning the battery, use soap
and water. Be careful not to get soap and water into
the battery. Clean the battery terminals with a solu-
tion of four parts water and one part baking soda
when they become corroded.
WARNING
Shorts caused by battery terminals or metal tools touch-
ing metal mower components can cause sparks. Sparks
can cause a battery gas explosion which will result in per-
sonal injury.
• Prevent the battery terminals from touching any
metal mower parts when removing or installing the
battery.
• Do not allow metal tools to short between the bat-
tery terminals and metal mower parts.
WARNING
Incorrect battery cable routing could cause damage to the
mower and battery cables. This can cause sparks which
can cause a battery gas explosion which will result in per-
sonal injury.
• Always disconnect the negative (black) battery
cable(s) before disconnecting the positive (red)
cable(s).
• Always connect the positive (red) battery cable(s)
before connecting the negative (black) cable(s).
Figure 4-2
WARNING
Hydraulic fluid escaping under pressure may have
sufficient force to penetrate skin and cause serious
injury. Foreign fluid injected into the skin must be
surgically removed within a few hours by a doctor,
familiar with this form of injury, or gangrene may
result.
Before applying pressure to hydraulic system, make
sure all connections are tight and all hoses and lines
are in good condition. To find a leak under pressure,
use a piece of cardboard or wood — never use your
hands. Relieve all pressure in the system before dis-
connecting or working on hydraulic lines. To relieve
pressure, lower all attachments and shut off engine.
Master fuse
housing
Starter