HUSTLER ATZ, Руководство оператора, Страница: 18 / 48

REV C 3-4 604243
Control Panel
IMPORTANT:
When access is required under the seat plat-
form and the seat is equipped with the optional arm rests, make
certain to place the control arms in the park brake position and
pivot the arm rests upward before placing the seat platform in
the full forward position to prevent arm rest damage.
A. Deck clutch switch (Figure 3-1) — this switch engages
the deck. Pull the switch up to engage and push switch
down to disengage the clutch.
IMPORTANT:
For additional clutch information refer
to the Mower deck operation section of this manual.
B. Ignition switch (Figure 3-1) — a three position switch:
“OFF”, “RUN”, and “START”. With key inserted, rotate
it clockwise to “START” position; release key when
engine starts, and switch will automatically return to the
RUN position.
C. Oil pressure light (Figure 3-1) — this light comes on
when the ignition switch is placed in the RUN position
and stays lit until the engine is running and a safe oil
pressure is developed. If light comes on during operation,
shut engine off immediately and locate and correct the
problem.
D. Throttle control (Figure 3-1) — a cable is linked to the
engine throttle for controlling engine speed. Move lever
forward to increase engine rpm, move lever rearward to
decrease engine rpm.
E. Choke control (Figure 3-1) — a cable is linked to
manually operate the engine choke. When the lever is in
the down position, the choke is in the off (run) position.
When the knob is pulled up, the choke is in the on (start)
position.
Do not operate the machine in the on (start)
position.
NOTE:
The choke control is not used on
mowers with fuel injected engines.
F. Electronic hour meter (Figure 3-1 & Figure 3-2) —
registers 1/10 hour increments up to 9,999.9 total hours.
Connected to the ignition switch, the meter records the
accumulative time while the ignition key is switched to
the RUN position.
G. 10 amp fuse (Figure 3-1) — Ignition system - 10 amp,
blade-type.
H. 20 amp fuse (Figure 3-1) — Safety system - 20 amp,
blade-type.
I. Fuel tank gauge (Figure 3-1 & Figure 3-2) — this
gauge shows the fuel level for each fuel tank. The right
gauge indicates the fuel in the right tank and the left
gauge indicates the fuel level in the left fuel tank.
Controls
A. Steering control levers (Figure 3-3 & Figure 3-4) —
these levers control the mower’s speed, direction,
stopping, and park brake. These levers are used to steer,
accelerate, decelerate and change direction. When the
steering control levers are in the park brake position the
A. Deck clutch switch
B. Ignition switch
C. Oil pressure light
D. Throttle
E. Choke
F. Hour meter
G. 10 amp fuse
H. 20 amp fuse
I. Fuel gauge
Figure 3-1 Figure 3-1
E
B
G
F
C
D
H
I
A
A
E
F
C
B
D
G
H
Units without fuel gauge
Figure 3-2
I
F