HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
REPLACING LAMP HOLDERS AND
END CAPS
The Impact lamp holder is designed to snap into
the sheet metal of the case. The lamp holder has a
locking ‘nub’ which fits inside the groove of
specially designed end caps.
IMPORTANT!
Always replace lamp holders and end caps with
Hussmann lamp holders and end caps.
Use of non-Hussmann parts may result in poor
electrical contact and short lamp life.
REPLACING DAMAGED DRAIN FITTING
The following procedure is for the field repair of a
broken drain fitting.
1. Use a drill with a 1
7
/
8
-in. (48 mm) hole saw to
drill out the bottom of the drain fitting. Be sure
to drill completely through fitting and bottom
liner.
2. Apply teflon tape to threaded end of adapter
and screw into threaded end of tee.
3. Apply an ABS and PVC compatible primer
and sealer to adapter and inside of drain. Insert
adapter into drain fitting.
Groove
Hussmann
End-Cap
Nub
Hussmann
Lamp Holder
Drain Fitting
Viewed from Inside Merchandiser
Foam Bottom Assembly
Modified
Drain Fitting
PVC Adapter – 1
1
/
2
x 1
1
/
4 inch (38 x 32 mm)
(obtained at local building supply store)
Tee 1
1
/
4 in.
(32 mm)
TxSxS
End Section View