Hussmann Chino MPC-ET Series, Руководство по установке и эксплуатации

Страница: 17 / 20

17
Service
WARNING !
DISCONNECT THE ELECTRICAL POWER WHEN SERVICING OR REPLACING ANY ELEC-
TRICAL COMPONENT.
Produce and Deck Pan Assembly
Gain access to Coil fan assembly
Lift bottom case deck pan using illustrated finger/ac-
cess hole to gain access to coil and fan assembly .
DECK PAN FINGER HOLE
To access compressor area
Remove all screws around the perimeter of the ac-
cess panel behind the case to expose compressor
unit and condensate pan through open section of the
rear wall.
Preventative Maintenance
(To be performed by trained service personnel)
Warning! Turn Off case before performing Preventive
Maintenance!
Condenser Coil:
a. Remove rear panel.
b. Using vacuum, vacuum and brush to dislodge and
remove dust on and in coil. Caution! Coil fins are sharp.
Handle with care! Do not bend fins!
c. Replace rear panel
Preventative Maintenance
Label (see pg. 22)
T-STAT LOCATION
Thermostat Sensor Access
Removing the rear interior wall will allow for acces to
the Thermostat Sensor placed above the Coil against
the rear wall.
FOR PROMPT SERVICE
When contacting the factory regarding problems,
be sure to have the Case Model and Serial
Number handy. This information is on a plate
located on the case itself.