5. When the blades are correctly adjusted the play
between the blades should be 0,2–0,4 mm,
measured at the screws.
6. The edges of the blades are too hard to be filed. Dull
blades should be sharpened using a grinder.
7. Replace the blades if they are bent or damaged.
Hot surface
The gear housing gets hot when the product has been in
use. Do not touch the gear housing to avoid burning
yourself.
Safety instructions for maintenance
Read the warning instructions that follow before you use
the product.
• Always stop the product before you work on any part
of the cutting equipment. If you have a gasoline
operated product, disconnect the spark plug cap
from the spark plug. If you have a battery operated
product, remove the battery. Check that the cutting
equipment has stopped completely before you start
any work on it.
• The transport guard should always be fitted to the
cutting attachment when the product is not in use.
• Make sure the cutting attachment has stopped
before cleaning, carrying out repairs or an
inspection. If you have a gasoline operated product,
disconnect the spark plug cap from the spark plug. If
you have a battery operated product, remove the
battery.
• Always wear heavy-duty gloves when repairing the
cutting attachment. This is extremely sharp and can
easily cause cuts.
• Store the product out of reach of children.
• Use only original spare parts for repairs.
Assembly
To assemble the hand guard and loop
handle (HA110)
WARNING: Never use HA110 with a battery
operated power unit.
1. Loosen the clutch sleeve’s two mounting bolts and
dismantle the clutch sleeve.
2. Assemble the hand guard and loop handle by
screwing them together. Take care to align the holes
in both parts.
3. Slide the loop handle and hand guard onto the shaft.
4. Slide the spacer into the slot in the loop handle.
5. Fit the nut and screw. Do not overtighten.
820 - 002 -
7
