12 SERVICE WORK ON THE CHASSIS
58
12.8
Installing the fork legs
402556-10
Main work
–
Position the fork legs.
Bleeder screws
1
are positioned toward the front.
Info
The compression damping is located in left fork
leg
COM
(white adjusting screw). The rebound
damping is located in right fork leg
REB
(red adjusting
screw).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
must be flush with the upper edge of the upper triple
clamp.
K00601-11
–
Tighten screws
2
.
Guideline
Screw, top triple
clamp
M8
17 Nm (12.5 lbf ft)
–
Tighten screws
3
.
Guideline
Screw, bottom triple
clamp
M8
15 Nm (11.1 lbf ft)
S02106-10
–
Position the brake caliper, and mount and tighten screws
4
.
Guideline
Screw, front
brake caliper
M8
25 Nm (18.4 lbf ft)
Loctite
®
243™
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and
tighten screws
5
.
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
12.9
Removing the lower triple clamp
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove front fender. (
–
Remove the handlebar cushion.
Содержание FE 450 2018
Страница 1: ...OWNER S MANUAL 2018 FE 450 FE 501 Art no 3402177en ...
Страница 2: ......
Страница 56: ...11 TUNING THE CHASSIS 54 Info Make sure the gap width is even ...