Husqvarna FC 450 2018, Руководство по ремонту

Страница: 213 / 335

ENGINE 17
Guideline
Screw, rocker arm
bearing
M7
15 Nm (11.1 lbf ft)
- Remove special tool
0.
I
Feeler gauge (590290411 00) ( � p. 311)
- Repeat these operations on the rocker arm of the exhaust
side.
17.4.36 Checking the clutch
- Check clutch throw-out
O
for damage and wear.
If there is damage or wear:
- Change the clutch push rod.
- Place the clutch push rod
8
on a flat surface and check for run-out.
If there is run-out:
- Change the clutch push rod.
- Check spring retainer
(D
for damage and wear.
If there is damage or wear:
- Change the spring retainer.
- Check pretension ring
C,
for damage and wear.
If there is damage or wear:
- Change the pretension ring.
- Check spring washer
0
for damage and wear.
If there is damage or wear:
- Change the spring washer.
- Check the contact surface of clutch pressure cap
(D
for damage and wear.
If there is damage or wear:
- Change the clutch pressure cap.
- Check clutch center @ for damage and wear.
304690-10
41
211