English - 49
6. MENU FUNCTIONS
Different corridor widths can be set for the
boundary wire, guide 1 and on guide 2. The
default setting on Automower
®
is set to a value of
10 for both the boundary wire and guide wires.
The higher the stated
Corridor width
value, the
less risk there is of tracks forming. However, a
high corridor value means that Automower
®
may
find it difficult to enter passages.
A garden with large open areas should have a
wide
Corridor
, i.e. a high
Corridor width
value.
A garden with passages should have a narrow
Corridor
, i.e. a low value for the
Corridor width
.
When the value is set to 0 for the
Corridor width
,
Automower
®
will run along the boundary wire,
which means it will run with half the mower inside
the loop and half the mower outside. As there
are often flower beds, hedges and walls along
with the boundary wire
Corridor
width
0 is not
normally recommended. Should you still like to
state this value, the boundary wire must lay
50 cm from solid objects instead of the normal
40 cm.
•
Test IN (3-2-4)
The
Test IN (3-2-4)
function is used to test how
Automower
®
finds its way into the charging
station.
IMPORTANT INFORMATION
The distance at which the mower follows the
boundary wire varies depending on how the
working area appears. You should perform
some tests to find the highest possible
Corridor width. Use the Test IN (3-2-4)
function to try different values.
3-2-3
Boundary corridor
Guide 1 corridor
Guide 2 corridor
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
3-2-4
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
