Husqvarna 570 AT, Руководство по ремонту

Страница: 13 / 58

SAFETY.EQUIPMENT
English – 13
WARNING!.
Ensure.that.the.spring.does.not.fly.out.
and.cause.personal.injury..Wear.protec-
tive.glasses..
!
Assembly
Assemble the chain brake as follows:
1. Fit the toggle joint and brake band.
2. Grease the moving parts of the toggle joint (D) and
fit the unit on the chain saw. See fig. 6.
3. Compress the spring using a conical screwdriver
6.5 mm wide and press it down with your thumb.
See fig. 7.
4. Grease and fit the lever (A). See fig. 6.
5. Grease and fit the retaining bush (B) with spring (C).
See fig. 5.
6. Fit the cover over the chain brake mechanism. Four
bolts (B). Tighten the bolts to 4 Nm. See fig. 1.
7. Fit the chain guide-plate with bolt (A). See fig. 1.
8. Fit the hand guard with the sleeve on the starter
side. See fig. 8.
9. Push back the hand guard so that the chain brake
is in the off position.
10.Check that the brake strap is correctly positioned in
the recess in the crankcase. See fig. 9.
11.Grease in the needle bearing before fitting. Fit the
clutch drum (E) with needle bearing (D) and chain
drive sprocket (C). See fig. 3.
12. Fit the washer (B) and locking ring (A). See fig. 3.
13.Fit the cylinder cover, chain and bar. See Operator's
Manual.
Fig. 6
Fig. 9
6.5mm
Fig. 7
Fig. 8
D
A
C B
A