Husqvarna 325HDA, Руководство по ремонту

Страница: 34 / 40

34
504 90 00-02
4 mm
504 90 00-01
6 mm
9
Cutting equipment
Remove the screws holding the
cutting equipment and lift off the
cutting equipment.
Remove the gear assembly as a
single unit.
NOTE!
The nuts on the eccentric cams have
left-hand threads. The connecting rod
has a needle bearing on the big end,
exercise great care so that it does not
fall apart. The needles lie loosely in the
holder.
Remove the nuts holding the eccentric
cams.
Remove the lower eccentric cam,
washer, upper connecting rod, upper
eccentric cam, and the gear from the
axle.
If the small gear is damaged or the
bearing for the clutch drum’s gear axle
is to be replaced, then the gearbox
must be removed from the engine.
Remove the clutch drum’s screw,
washer and the clutch drum. Counter
hold using the hexagon grip on the end
of the axle.
When replacing the bearing, heat the
housing using a hot air gun before
removing and inserting.
Bearing clutch drum 32 mm, punch
502 71 35-01.
Bearing gear assembly upper 22 mm,
punch 502 50 30-13
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com