Husqvarna 325HDA, Руководство по ремонту

Страница: 21 / 40

21
!
5
503 98 96-01
WARNING!
Wear gloves!
Make sure the blades move easily.
Place one of the wear washers in
position in the gearbox.
Turn the wear washer with rounded
edges towards the blades.
Fit and tighten the outer screws for the
support plate with washers as normal.
Fit the lock nut.
Loosen the screw a 1/4 turn and check
that the washer moves.
Tighten the lock nut.
Assembling
325DA55, 325HE3, 325HE4
Use weak nut lock fluid when assem-
bling.
Lubricate the components with grease
503 98 96-01 when assembling.
Fit the bearing and circlips.
Fit the cutting equipment.
Fit the support plate for the cutting
equipment.
Remove the circlips for the bearings.
Heat using a hot air gun to approx.
125
°
C and press out the bearing.
The eccentric cam’s bearing, 27 mm
punch 502 50 30-04,
crown wheel axle’s bearing, 22 mm
punch.
Remove the bearing.
Two screws, the outer accessible
through the hole in the cutting equip-
ment when the blades are moved.
Remove the cutting unit.
Lift the blades a little using a screw-
driver and remove the remaining
connecting rod.
Remove the wear washer.
Gear
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com