Husqvarna 325HDA, Руководство по ремонту

Страница: 33 / 40

33
9
Dismantling the
gearbox
325HS75, 325HS99:
Remove the screws holding the cover.
Lift off the cover.
Replace the bearing if necessary:
Remove the screws holding the
engine on the gearbox, release the
electrical cables and remove the
engine.
Replace the bearing:
Heat the cover with a hot air gun to
approx. 125
°
C.
Knock the cover against a wooden
surface, open carefully with a
screwdriver if necessary.
When assembling press the bearing
against the stop, check that the
bearing race lies under the edge of
the housing.
Sealed bearing 26 mm punch 502 52
05-01, Non-sealed bearing 28 mm
punch
502 50 30-04.
Remove the guide plate.
Remove the felt seal.
Remove the thrust washer.
Remove the flat washer.
Remove the lower connecting rod.
Remove the three lock nuts for the
blades and support plates.
NOTE!
The connecting rod has a needle
bearing on the big end, exercise
great care so that it does not fall
apart. The needles (53) are loose in
the holder.
Cutting equipment
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com