Husqvarna 322, Руководство по ремонту

Страница: 30 / 34

29
6
503 26 70-01
Cylinder and piston
Lubricate the piston with a few drops of
oil and carefully slide the cylinder over
the piston.
NOTE!
Do not turn the cylinder as the piston
ring can easily break.
Tighten the 4 bolts crosswise.
Fit other components in the reverse
order as stated for dismantling.
Carefully slide down the cylinder over
the piston and tighten the 4 bolts
crosswise.
Clean the old sealant and grease from
the contact surfaces on the base of the
cylinder.
Apply a narrow string (1 – 1.5 mm) of
sealant No. 503 26 70-01 to the contact
surface.
NOTE!
The sealant does not need to be
applied to the bearing's contact surface.
Clean the contact surface on the base
of the cylinder and apply a narrow
string of sealant No. 503 26 70-01 to
the sealing surface.
Clean any sealant or grease from the
crankcase.
Fit the piston on the connecting rod so
that the arrow on top of the piston
points towards the exhaust port. See
the instructions in the Workshop
Manual.
Clean the sealant from the crankcase
and fit the piston on the connecting rod.
Assembly
Before the piston and cylinder and fitted
parts should be cleaned and inspected
as instructed in the Workshop Manual.
Check that the rubber intake manifold
between the cylinder and distance
piece has not cracked or shows signs
of other damage that can cause leaks.
Assembly
Clean and inspect the piston and
cylinder. Check the rubber intake
manifold with regard to crack formation
or other damage.
6 Eng, 27-30 98-12-14, 17.09 29