Husqvarna 322, Руководство по ремонту

Страница: 15 / 34

14
3
A
B
A
Fuel system
Assembly of the throttle is carried out in
the reverse order as stated for disman-
tling.
Position the components in the left-
hand throttle half.
Make sure the return spring (A) is
turned the right way.
Check that the throttle cable and short-
circuiting cable are pressed down
correctly in respective channels so that
they are not crushed when the two
throttle halves are bolted together.
Do not forget to place the vibration
element (B) in position before the
throttle halves are put together. Lubri-
cate the vibration element using soapy
water. This facilitates fitting the throttle
onto the shaft.
Fit together the throttle halves using the
5 bolts, but do not tighten them fully
until the throttle has been slid into
position on the shaft.
Assemble other components in the
reverse order as stated for dismantling.
Remove the bolts that hold together the
throttle and carefully separate the two
halves.
Note how the different components are
fitted. Pay special attention to which
way the return spring (A) is turned.
The stop contact can be pried off using
a small screwdriver if it needs to be
replaced.
3 Eng, 11-18 98-12-14, 17.07 14