Husqvarna Viking Sapphire 830, Руководство пользователя

Страница: 15 / 48

15
1
A
B
C
A
B
C
A
B
C
Getting ready to sew
Winding the bobbin using the vertical
spool pin
1. Place an empty bobbin on the bobbin spindle at the front of
the machine (the Husqvarna Viking mark facing up). Use only
the original Husqvarna Viking bobbins.
2. Place the large spool holder and a felt pad under the spool on
the main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B), then
through thread guide (C) as illustrated.
4. From above, wind a few turns of thread clockwise around
the bobbin. Push the bobbin spindle to the right. Cut off the
thread on the thread cutter.
5. Press the foot control to start winding. When the bobbin is
full it will stop automatically. Push the bobbin spindle back
to the left. Remove the bobbin and cut off the thread on the
thread cutter.
Winding the bobbin using the auxiliary
spool pin
1. Place an empty bobbin on the bobbin spindle at the front of
the machine (the Husqvarna Viking mark facing up). Use only
the original Husqvarna Viking bobbins.
2. Fold out the auxiliary spool pin. Place a large spool holder and
a felt pad under the spool.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B), then
through thread guide (C) as illustrated.
4. From above wind a few turns of thread clockwise around
the bobbin. Push the bobbin spindle to the right. Cut off the
thread on the thread cutter.
5. Press the foot control to start winding. When the bobbin
is full the winding will stop automatically. Push the bobbin
spindle back to the left. Remove the bobbin and cut off the
thread on the thread cutter.
Placing the bobbin in the machine
Turn off the main switch
1. Remove the bobbin cover by sliding it towards you.
2. Place the bobbin in the bobbin case with the Husqvarna
Viking mark facing up. The bobbin will then rotate counter
clockwise when you pull out the thread.
3. Place your fi nger on the bobbin to keep it from turning as you
pull the thread fi rmly to the right and then to the left into the
tension spring (A) until it ‘‘clicks’’ into place.
4. Continue threading around (B) and into the thread cutter (C).
Replace the cover (1). Pull the thread to the left to cut it (2).
NOTE:
Depending on the type of thread, wrap the
thread one or two turns around the bobbin thread
tension disc (B) to put more tension on the thread.