2
3
LOW BATTERY ALARM
A low battery alarm will sound once every 5 minutes for a total of 12 times within 1 hour, to
remind you to recharge your flashlight.
BATTERY REPLACEMENT
Occasionally, even rechargeable batteries need replacing
1. Remove screw at the base of battery cover.
2. Pull gently up on the battery cover to remove.
3. Remove and replace 4 rechargeable batteries.
4. Replace batteries in same position as removal.
BATTERY DISPOSAL
Dispose of used batteries properly. For more information on recycling batteries, please call toll
free (800) 822-8837.
RECHARGING
The charging adapter rating is 7.2 volts, 500mA. The charging time for the flashlight is
approximately 2.2 - 2.5 hours. While charging the LCD display will show
CH
, the battery symbol
will flash. The flashlight is fully charged when the battery symbol stops flashing. If there is a power
failure during charging, the LCD display will show
PF
and the night light will flash.
NOTES
: Flashlight can be recharged only if rechargeable type batteries are used. Alkaline and standard batteries are not
rechargeable. To recharge: Place flashlight in wall mounted holder, attach recharger to flashlight recharge port
and plug into wall receptacle.
Digital display accuracy will be affected if unit is near full discharge level, display will not read accurate remaining
run times unless unit has at least a minimum required charge level.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Figure 1. Digital Electronic Flashlight
1
1 Halogen Beam
2 Screw
3 3 LEDs
4 Recharge Port
5 Battery Cover
6 ON/OFF Pushbutton
7 LCD Digital Display
7
3
5
2
6
4
Figure 2. Lens Assembly
Rubber Guard Cover
Twist Out Bulb
Reflector
Rubber “O” Ring
Lens
Retaining Ring
HSK155_Manual_072505.qxd 7/26/05 4:01 PM Page 2
