ii
1
Congratulations on selecting the Husky Digital Electronic Flashlight.
• Ideal for temporary power outages or emergencies - always be prepared!
• Built-in 3 LED long lasting area light on handle
• LCD digital display shows charge level and run time remaining
• Dock-mount charger - Fully automatic
• Operates on 4 rechargeable Ni-Cd batteries (included)
• Power fail night light
• Break resistant “O” ring sealed polycarbonate lens
WARNING
: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS.
OPERATION AND SEQUENCING
The Digital Electronic Flashlight is sequenced. The flashlight will react differently with each press of
the ON/OFF pushbutton.
• 1st Press:
Halogen beam is ON; digital display shows how much run time remains and
battery charge level.
• 2nd Press:
3 built-in LEDs are ON and digital display shows how much LED run time remains
and battery charge level. (LED run time displays only when LED is on.)
• 3rd Press:
All lights are OFF.
• Press and hold (2 seconds): All lights are ON.
Charging time is approximately 2.2 - 2.5 hours. Display will show
LO
when batteries are low and
beep 3 times. The low battery symbol will also flash and light will shut off.
BULB REPLACEMENT
1. Twist to unlock the Rubber Guard Cover from the Retaining Ring (Figure 2).
2. Gently remove the Retaining Ring, Lens, “O” ring and Reflector and put aside.
3. Twist counterclockwise and remove Halogen bulb from socket.
4. Replace halogen bulb with HR53, 5.2v, 0.8 amps bulb, available through Husky Technical
Support.
NOTE:
This device complies with part 15 of FCC rules. Operation is subject to the following conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
HSK155_Manual_072505.qxd 7/26/05 4:01 PM Page ii
