Huskie Tools HH1500, Руководство по обслуживанию

Страница: 24 / 60

24
Table 9. New Component Dimensions
PART HH1500 HH2000 HH3600 HH4500 HH5800 HH8000
Front Cap Bushing I.D.
101. mm.
3.967 in.
116. mm.
4.567 in.
136. mm.
5.354 in.
146. mm
5.748 in. 156. mm
6.142 in. 166. mm
6.535 in.
Shank Bushing I.D.
101. mm.
3.967 in.
116. mm.
4.567 in.
136. mm.
5.354 in.
146. mm.
5.748 in.
156. mm
6.142 in. 166. mm
6.535 in.
Tool O.D.
100. mm.
3.937 in.
115. mm.
4.528 in.
135. mm.
5.315 in.
145. mm.
5.709 in.
155. mm
6.102 in. 165. mm
6.496 in.
ASSEMBLY
Note: Clean every part before assembly. Keep parts clean and do not scratch during
assembly. Assembly can basically be done in the reverse order of disassembly. Make
sure parts are installed in the correct direction.
1. Lubricate the U-packing, O-ring, piston, cylinder and main valve with hydraulic oil
before assembly.
2. Place cylinder sleeve on the piston.
3. Insert the piston fully into the cylinder to its bottom position.
a. Make sure that all seals are positioned correctly and facing the right direction.
b. Handle seals very carefully in order not to cause scratches.
c. To avoid scratching the piston, the cylinder sleeve can be installed with a plastic
hammer or nylon bar.
4. Install the front cap on the cylinder.
5. Insert the main valve and the outer sleeve.
6. Apply hydraulic oil into the back cap for gas seal lubrication. See Figure 18.
7. Attach the back cap to the cylinder.
Figure 18. Adding oil to the Back Cap.
HH1500 1.0 oz. or 30 cc.
HH2000 3.5 oz. or 100 cc.
HH3600 5.0 oz. or 150. cc.
HH4500 5.0 oz. or 150. cc.
HH5800 5.0 oz. or 150. cc.
HH8000 6.0 oz. or 180. cc.