INSTALLATION
10
STEP 4: Connect the Power Source
NOTE:
When power is connected to the motor, a blue LED inside the control button housing
will flash to indicate the shade is ready for operation.
■
Refer to the appropriate page based on your order.
➤
For a battery wand, see below.
➤
For an optional satellite battery pack, see page 12.
➤
For an optional headrail-mounted rechargeable battery wand, see page 12.
➤
For an optional satellite-mounted rechargeable battery wand, see page 12.
➤
For an optional 18V DC Power Supply, see page 14.
➤
For an optional 18V DC Power Supply with daisy-chain connections, see page 15.
➤
For any other Hunter Douglas power options, see the instructions that came with
the unit.
Install the Battery Wand
NOTE:
Battery wand is stored in the front of the headrail. Reference the label on the front of
the headrail for location.
■
Plug the power cable into the battery wand.
■
Press the control button to lower the shade at least 12" in order to create space to install
the battery wand.
NOTE:
The control button is located at the right hand side of the headrail below
the endcap.
■
Locate the clips inside the headrail in front of the fabric roll, as shown.
■
To install, place the wand against the inside of the front of the headrail then push up until
the battery wand locks into place and clicks.
NOTE:
Listen for a “click” when installing the battery wand to make sure it is inserted all
the way into the clips.
NOTE:
To remove the battery wand, reach your fingers inside the front of the headrail
where the battery wand is located. Find the lip on the end of the wand and pull down.
Proceed to “Testing the Shade” on page 16.
Battery
Clip
Front of
Headrail
