HunterDouglas Pirouette PowerView, Установка Эксплуатация Уход

Страница: 22 / 32

OPERATION
20
Problem
The shade limits need to be adjusted — top limit.
Solution
Adjusting the Top Limit
NOTE:
Fine adjustment mode timeout is 60 seconds. If there is no action
within 60 seconds, fine adjustment mode exits.
■ ■
Move the shading to the current top limit position. See“Basic Operation”
on page 15.
■ ■
On the remote, ensure that the ALL button and the group number buttons
are not selected.
■ ■
Fine Adjustment Mode — Press and hold the programming button on the
shading.
■ ➤
While holding the programming button, press and release the  OPEN
button on the remote.
■ ■
Release the programming button. The shading will move to the top limit
position, if not already there and the LED behind the programming button
will turn solid red to indicate the shading is in fine adjustment mode.
■ ■
On the remote, make sure the group number for the shading is selected
and the other group numbers are de-selected.
■ ■
Press  OPEN or  CLOSE on the remote and the shading should move
at a slow speed.
NOTE: If the shading does not move at a slow speed, repeat the
previous steps.
■ ■
When the desired top limit location is reached, press the

STOP button
on the remote.
■ ■
Press and hold

STOP on the remote until the indicator lights on
the remote blink (approximatley 6 seconds). The remote is now in
programming mode. Ensure none of the group buttons are selected on the
remote.
■ ➤
While the remote is in programming mode, press and hold the
programming button on the shading.
■ ■
Press the  OPEN button on the remote. The shading will move slightly
twice to indicate the new top limit is set. The LED will flash green and
then turn off.
■ ■
Exit programming mode on the remote. Press and hold

STOP on the
remote until the indicator lights stop blinking (approximately 6 seconds),
or let the remote time out (approximately 20 seconds).
■ ■
Verify the new top limit by moving the shading down and then up.