HunterDouglas Pirouette PowerView, Установка Эксплуатация Уход

Страница: 8 / 32

INSTALLATION
6
Mount the Installation Brackets — Outside Mount
Mount the Installation Brackets
■ ■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark the wall at each end of the headrail.
■ ➤
Alternatively, measure the width of the headrail and use that width to mark the
headrail end points over the window opening.
■ ■
Mark 2" from each end of the headrail.
■ ➤
If more than two installation brackets came with your order, space additional bracket(s)
evenly between the two end brackets and mark their location. Mount into wood
whenever possible.
Allow a minimum of 18" from the motor side for the battery
wand.
NOTE: Before the headrail is installed, the bracket levers need to be fully to the left .
Once the headrail is properly in place, the levers automatically click to the right.
■ ■
Center the installation brackets or extension brackets on your marks and mark where to
drill the screw holes.
■ ➤
A minimum 1" flat vertical surface is required for the installation brackets. Extension
brackets require 1
1
⁄
4
".
■ ➤
The top of the installation brackets or extension brackets should be at the desired
height. The brackets should be level and aligned to each other.
CAUTION: The rear of the brackets must be flush against a flat mounting surface. Do not
mount brackets on curved molding.
Extension
Bracket
1
1
⁄
4
"
1"
Headrail End Marks
Window Opening
Motor
Side
18" Minimum for Battery Wand
Space Evenly Space Evenly
2"
2"