INSTALLATION
14
Attach the Wand (If Ordered)
If the blind was ordered with a wand tilter, attach the wand to the metal shaft.
NOTE:
Wands may appear different from the illustration, but assembly is the same.
■
Pull the plastic sleeve from the top of the wand and insert it over the metal shaft.
■
Insert the hook on the wand through the hole in the metal shaft.
■
Slide the plastic sleeve down over the hook until firmly seated.
■
Test the wand tilter.
Attach the Valance with Magnetic Valance Clips to the Headrail
■
Align the valance to the headrail.
■
Hold the valance securely from the front side with both hands.
■
Position the clips to the top-front lip of the headrail until
it is level and in position.
■
Press the valance gently forward, just enough so the clips
adhere to the headrail.
■
The magnetic valance clips allow for limited valance height
adjustments by carefully sliding the clip up or down while the
magnets are adhered to the headrail. The clip’s tabs rest on
the top-front lip of the headrail, keeping the valance level and
preventing the valance from adjusting lower beyond that point.
■
To remove the valance, gently pull the valance up and toward you.
CAUTION:
The entire surface area of the magnet inside each clip needs to maintain
clean contact with the front surface area of the headrail at all times.
Plastic
Sleeve
Hook
Metal
Shaft
Slide
Sleeve
Over
Shaft
Hook
Through
Hole
Slide
Sleeve
Over
Hook
Wand
