WARNING:
Blind Cords may create a
strangulation hazard for young children.
KEEP BLIND CORDS OUT OF REACH OF CHILDREN.
Your Windoware Shade Cloth Roll Up Blind
comes complete with all parts and fixing
accessories for a quick and easy installation.
The only tools you will require are a 1/8” drill
bit, a Phillips Head screwdriver, tape measure
and a pencil.
STEP 1
First decide where
your Shade Cloth
will go. Keep it rolled
up and hold the
headrail in place
where you would like
it installed.
STEP 2
Check the base
material behind the
headrail to make sure
it is suitable for the
screws provided. Mark
the points where you
will drill holes making
sure to keep the
headrail level.
STEP 3
Drill holes in the
marked points on the
base material.
STEP 4
Position the headrail over the
holes and using the Phillips
Head screwdriver, secure it
to the wall with the screws
provided.
STEP 5
Open the Fabric so it falls full
length. Apply a bit of tension to
the Shade Cloth at the bottom,
connect the anchor plates
onto each end of the base
rail and mark the points where
the anchor plates are to be
secured.
STEP 6
Drill into the base material
at the marked points,
then secure the anchor
plates with the screws
provided.
STEP 7
Now you can place the
base rail in the anchor
plates to hold it in a
fully open drawn down
position.
STEP 8
To install the rope cleat, hold
it in position, mark points,
drill then fix the rope cleat
into position using the screws
provided. The cleat should be
placed so that the pull cord
will be out of reach of children
(at least 1.6m above floor
level). Wind the cord tightly
around the cleat making sure
that none of it can be reached
or grasped by young hands.
To avoid creating a possible strangulation hazard for children, the corded internal window covering must be
installed in such a way that a loose cord cannot form a loop 220mm or longer at a height of less than 1600mm
above floor level.
- A cord guide may be installed lower than 1600mm above floor level if the cord is sufficiently secured or
tensioned to prevent a loop 220mm or longer from being formed.
- If a cord guide is installed lower than 1600mm above floor level it must be designed to prevent a child from
being able to remove the cord.
- If a cleat is used to secure the cord it must be at least 1600mm above floor level because a child is capable of
unwinding a cord from a cleat.
furnishing solutions with style!
INSTALLATION INSTRUCTIONS
SHADE CLOTH ROLL UP BLIND
