HunterDouglas Duette PowerView, Установка Эксплуатация Уход

Страница: 22 / 32

OPERATION
20
Further Operation and Programming Information
PowerView
®
Pebble
®
Remote and/or PowerView
®
Surface Remote
Operation
For information regarding operation and programming of the PowerView
®
remote, refer to your
PowerView
®
Motorization Remote Control Guide or to the online PowerView Step-by-Step
Guide at hunterdouglas.com/operating-systems/motorized/powerview-motorization/
manuals .
PowerView
®
Scene Controller
For information regarding operation and programming of the PowerView
®
Scene Controller,
refer to your PowerView Motorization Scene Controller Guide or to the online PowerView
Step-by-Step Guide at hunterdouglas.com/operating-systems/motorized/powerview-
motorization/manuals
.
PowerView
®
App Operation
The PowerView
®
Hub is required for PowerView
®
App operation. For information regarding
setup and operation using the PowerView App, refer to the online PowerView Step-by-Step
Guide at
hunterdouglas.com/operating-systems/motorized/powerview-motorization/
manuals .
Resetting the Shade, If Necessary
Calibration Reset
The calibration reset is used to recalibrate the shade’s travel limits.
1. Press and hold the programming button for approximately 6 seconds. The shade will move
slightly. Release the programming button (the light flashes red).
2. The shade will raise to its fully open position to reestablish the upper travel limit, then
lower to the fully closed position to reestablish the lower travel limit. The middle rail will
then move slightly twice (up, then down) to indicate that the travel limits were recalibrated.
Resetting Shade Programming
The programming reset erases shade programming from memory, including group
assignments, preventing input devices from operating the shade. The primary use is to correct
group and network assignments during installation. The reset does not affect travel limits or
the favorite position.
1. Press and hold the programming button for approximately 12 seconds. The shade will move
slightly after 6 seconds, then again after 12 seconds. Release the programming button (the
light flashes red). The light then flashes a series of green and red to indicate that shade
programming is erased from memory.
2. Refer to “Joining a Shade to a Group” on page 18 to program the shade to a group.