HunterDouglas Duette PowerView, Установка Эксплуатация Уход

Страница: 20 / 32

OPERATION
18
Using the PowerView
®
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
®
Shade Network” in the PowerView
®
Motorization Remote Control Guide.
Joining a Shade to a Group
IMPORTANT: The shade will not operate using the remote until it has been joined to
a group.
1. Press and hold
■■
STOP on the remote until the indicator lights blink (approximately
6 seconds). The remote is now in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlit group number will flash
to show it is selected.
3. While pressing the programming button on the shade, press
▲■
OPEN on the remote. The
green light flashes once and the shade will move slightly twice (up, down, or down, up) to
indicate the shade has joined the group. Release the programming button.
4. Press and hold
■
STOP on the remote until the indicator lights stop blinking (approximately
6 seconds).
Group 1
Group 2
OPEN
Raises
middle and
bottom rail
CLOSE
Lowers bottom
and middle rail
Group 3
Group 4
Group 5
Group 6
Favorite
(Shade position)
LEFT ARROW
Lowers the middle rail
on Top-Down/Bottom-Up
and Duolite
®
shades
RIGHT ARROW
Raises the middle rail
on Top-Down/Bottom-Up
and Duolite shades
STOP
All shade movement stops
(Press and hold for programming
mode)