INSTALLATION
7
■
Use a level to check that the mounting surface is level. Shim the brackets if necessary.
Shims are not provided.
■
Attach the installation brackets using the screws provided.
Install the Cables
■
Thread all of the cable through the hole in
each bracket or cassette (not shown) end plate.
Install the Shade
Standard Shades
IMPORTANT:
Do not remove the paper banding used to prevent
shade from unrolling prematurely until after the shade is installed.
■
Hold the shade with the bottom of the clutch facing the floor,
and the beaded cord loop hanging straight down.
■
Install the clutch end of the shade onto the tab on the clutch-side
bracket.
■
On the idler-side, slide the spring pin up the channel until
secured in the center hole of the channel.
■
Remove the paper banding on the shade.
Tab
Spring
Pin
