ATTACHing SeleCToR CAP To THe Solenoid
the selector cap turns the solenoid when the user changes the on-auto-oFF settings. under normal operating
conditions, the selector cap should not need replacement. the selector cap can become damaged if the incorrect
tool is used to make on-auto-oFF selection adjustments.
With the Solenoid and Pilot Valve assembly installed in the flange compartment and the Solenoid set to the Auto
position (see instructions above), proceed as follows. The flat side of the Solenoid should be facing away from the
rotor’s riser assembly pointing towards the outside of the flange compartment (fig 142).
starting from where the solenoid’s lead wires come out of the top of the solenoid, place the lead wires side-by-side
over the top and down the flat side of the Solenoid (fig 143). While hold the Solenoid’s lead wires in this position,
place the selector cap on top of the solenoid. the selector cap must be oriented such that the solenoid’s lead
wires fit into the recessed channel on the inside wall of the selector cap. press the selector cap down and onto the
solenoid (fig 144).
FIg 143
FIg 144
Fig
142
Fig
143
Fig
142
Fig
143
50
Содержание G835
Страница 2: ......
Страница 21: ...Fig 47 Fig 49 Fig 50 Fig 48 Fig 48 Fig 47 Fig 48 Fig 47 18...
Страница 57: ...54...
