INSTALLATION
9
Install the Shade
Standard Shade
IMPORTANT:
Do not remove the paper banding used to prevent shade from unrolling
prematurely until after the shade is installed.
■
Hold the shade with the bottom of the clutch facing the fl oor, and
the bead chain loop hanging straight down.
■
Install the clutch end of the shade onto the tab on the clutch-side
bracket.
■
Swing the rotator side of the shade into
place so the rotator pin engages the
rotator-side bracket.
■
Rotate the T-hook down to close.
■
Remove the paper banding on the shade.
Cassette Shade
■
Angle the cassette back and then bring the
cassette forward to catch the front lip of
the bracket.
■
Push the cassette back to snap it into the
lower lip on the bracket.
Attach the Optional Components
Hold-Down Brackets
Hold-down brackets may be used with outside mount shades only.
■
With the shade fully lowered, insert the pin on the hold-down
bracket into the hole on the bottom rail end cap.
■
Mark the hole locations on the mounting surface.
■
Center the hold-down brackets over the mounting hole
locations and check their alignment. Attach using two screws.
IMPORTANT:
Disconnect the bottom rail from the hold-down brackets to raise the shade.
Clutch
Bottom
of the Clutch
Rotator Pin
Engaged
To Close the
T-Hook
Headrail
Front
Lip
Bracket
