Speed Dome Camera Instruction Manual
21/33
Check Points before Operation
z
Before turning on the system, check if the wire(s) and cable(s) are connected properly.
z
Check if the camera ID on the controller is properly selected. The camera ID must be
identical to that of the target camera. The camera ID can be checked by reading the DIP
switch of the camera or on Web browser.
z
If your controller supports multi-protocols, the protocol must be changed to match to that
of the camera.
z
Adjust the DIP switch after turning off the camera. If you changed the camera protocol by
changing the DIP S/W, the change will be effective after you reboot the camera.
z
Since the operation method can be different by controllers, refer to your controller manual
if the camera can not be controlled properly. The operation of this manual is based on the
standard Pelco® Controller.
z
For more information on IP Function and Web Brower, refer to our IP manual.
Check Points for Preset and Pattern Function before Operation
z
Check fully how to operate preset function and pattern function with your controller or DVR
in advance to operate the camera functions when using a controller or a DVR.
z
Refer to the following table when using standard Pelco® protocol controllers.
< Go Preset >
Input [Preset Number] and press [Preset] button shortly.
< Set Preset >
Input [Preset Number] and keep pressing [Preset] button for more than 2 seconds.
< Run Pattern > Input [Pattern Number] and press [Pattern] button shortly.
< Set Pattern >
Input [Pattern Number] and keep pressing [Pattern] button for more than 2 seconds.
z
If your controller or DVR has no pattern button or function, use the Hot Keys with preset
numbers. For more information, refer to
“Reserved Presets(Hot Keys)”
in this manual.
OPERATION
3
