Speed Dome Camera Instruction Manual
14/33
Installation with Ceiling Mount Bracket
①
Remove the ceiling tile from the ceiling
and cut a hole whose diameter is
30~40mm on the ceiling tile to pass the
wire(s) and cable(s) through to the upside
of the ceiling. (In case of the wiring and
cabling through the mounting surface
only) Then prepare the ceiling mount
bracket. Pull the wire(s) for the system as
below. (Anchor Bolt 3/8"
×
70)
②
Hook up “Drop Prevention Spring” on
main body to prevent camera from
unexpected drop and pull the wire(s) and
cable(s) for the system as below.
③
Line up the mold lines and assemble
main body to mount adaptor and turn it.
And assemble the main both with the
camera mount adaptor with the 3 screws.
(
TORX SCREW M4
×
18
).
④
Screw the dome cover to the main body
and remove the protection vinyl from the
dome cover.
Important Notice
z
Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
z
To adjust the installation height from the mounting surface, the pipe and coupler should be needed
between the surface mount part of the ceiling mount bracket and the camera mount part of the ceiling
mount bracket. Note that they are not supplied by the manufacturer.
INSTALLATION
2
