17
Connect the Transducer Cable - Install Accessories
C
ONNECT THE
T
RANSDUCER
C
ABLE
1. Connect the transducer cable connector to the proper port on the control head or black
box sonar (depending on your system configuration). The ports are labeled and the cable
connectors are keyed to prevent incorrect installation, so be careful not to force the
connector into the wrong port.
2. Hand-tighten the screw nut on the cable to secure the connection.
CAUTION!
Do NOT mount the cables where the connectors could be submerged in
water or flooded. If cables are installed in a splash-prone area, it may be helpful to
apply dielectric grease to the inside of the connectors to prevent corrosion.
Dielectric grease can be purchased separately from a general hardware or
automotive store.
I
NSTALL
A
CCESSORIES
If you have purchased additional accessories for your control head configuration, see the
installation guide provided with each accessory for installation instructions. See the
Network
Configuration
illustration for an example of possible network connections.
Ethernet:
Your unit has a built-in ethernet connector so that you can network advanced
accessories and multiple Humminbird units. The Ethernet cable requires a separate purchase.
See the Ethernet Installation Guide for details.
Adapter Cables:
Your installation may require adapter cables to connect accessories to the
control head.
NOTE:
To review the latest compatible accessories for your control head, and to
purchase cables or other equipment, go to
humminbird.com
or contact Customer
Service at
1-800-633-1468
.
Route and Connect Accessory Cables
1. See the installation guides included with each accessory for installation instructions.
2. Route the cables to the control head.
3. Pass the cables through the drilled hole(s), and connect them to the appropriate ports
on the control head. The ports are labeled, and the connectors are keyed to prevent
incorrect installation.
NOTE:
When the cables connect to the control head through the hole, leave enough
cable slack to allow for the control head to pivot through its full tilt range. Extra cable
slack will also help when connecting or disconnecting the cables.
4. Hand-tighten the screw nut on each cable to secure the connection. Any unused ports
should be covered with the port covers to prevent potential damage.
5. Apply labels to the cables (optional). Use nylon cable ties (not included) to secure the
cables and create a clean assembly.
Proceed to the section
Test and Finish the Installation
.
route cables
to control head
cable hole
dashboard
(partial view)
Routing the Cables
cable label
(optional)
port cover
screw nut
Securing the Cables
(magnified view)
Installing Accessories
Connecting the Transducer Cable
Содержание ONIX10
Страница 4: ......
