I
NSTALL THE
T
RANSDUCER
Review the transducer installation options and the transducer mounting requirements in the following sections. Then proceed to the
installation section for your transducer type as follows:
•
DualBeam PLUS Transducer
•
Side Imaging Transducer
NOTE:
If the included transducer will not work for your application, you can exchange it, NEW and UNASSEMBLED, with the transducer
mounting hardware included, for a transducer appropriate for your application. This offer applies to the DualBeam PLUS transducer only.
Visit
humminbird.com
for more information or call Customer Service at
1-800-633-1468
.
T
RANSDUCER
I
NSTALLATION
O
PTIONS
Your ONIX control head includes either a DualBeam PLUS transducer or a Side Imaging transducer. Depending on your transducer type,
there are different options available for mounting the transducer on the boat. Review the transducer installation options below.
Transom Transducer Installation
Available for the DualBeam PLUS transducer and the Side Imaging transducer.
Your transducer includes the transom mounting hardware. See
Transom Transducer
Installation
for additional information.
In-Hull Transducer Installation
Available for the DualBeam PLUS transducer only.
In-hull mounting generally produces good results in single thickness, fiberglass-hulled boats.
See
DualBeam PLUS Inside the Hull Installation
for installation instructions.
Humminbird cannot guarantee depth performance when transmitting and receiving through
the hull of the boat, since some signal loss occurs. The amount of loss depends on hull
construction and thickness, as well as the installation position and process.
NOTE:
This installation requires slow-cure two-part epoxy. Do not use silicone or any other
soft adhesive to install the transducer, as this material reduces the sensitivity of the unit. Do
not use five-minute epoxy, as it has a tendency to cure before all the air bubbles can be
purged, thus reducing signal strength.
NOTE:
The integral temperature probe will not work with in-hull mounting, so you may want
to consider purchasing a Temperature/Speed accessory, a Temp Sensor, or obtaining a
different transducer.
NOTE:
In-hull mounting requires an installed and operational control head.
Trolling Motor Transducer Installation
Available for the DualBeam PLUS transducer and the Side Imaging transducer.
You can purchase a Trolling Motor Adapter kit that will allow you to mount the transducer on
the trolling motor. If you already have a trolling motor bracket, refer to the separate installation
instructions that are included with the bracket.
NOTE:
Visit our Web site at
humminbird.com
for more information, or call Customer Service
at
1-800-633-1468
for details and pricing.
In-Hull Transducer Installation
Trolling Motor Transducer Installation
Transom Transducer Installation
4
Install the Transducer
Содержание ONIX10
Страница 4: ......