Humminbird 1157c Combo CHO страница 33 Скачать руководство пользователя

Страница: 33 / 200

To route the transom transducer cable:

The transducer cable has a low profile connector that must be routed to the point where the control head
is mounted. There are several ways to route the transducer cable to the area where the control head will
be installed. The most common procedure routes the cable through the transom into the boat.

NOTE:

Your boat may have a pre-existing wiring channel or conduit that you can use for the transducer cable.

Unplug the other end of the transducer cable from the control head. Make sure that the cable is
long enough to accommodate the planned route by running the cable over the transom.

CAUTION!

Do not cut or shorten the transducer cable, and try not to damage the cable insulation. Route the

cable as far as possible from any VHF radio antenna cables or tachometer cables to reduce the possibility of
interference. If the cable is too short, extension cables are available to extend the transducer cable up to a
total of 50' (15 m). For assistance, contact the Customer Resource Center at

www.humminbird.com

or call

1-800-633-1468

for more information.

NOTE:

Since the transducer may need to pivot up to 90° in the bracket if it strikes an object, make sure there

is sufficient cable slack to accommodate this motion. It is best to route the cable to the side of the transducer
so the cable will not be damaged by the rotation of the transducer.

2a. If you are routing the cable over the transom of the boat, secure the cable by attaching the cable

clamp to the transom, drilling 9/64" diameter holes for #8 x 5/8" wood screws, then skip directly
to procedure 5, Connecting the Cable.

or...

2b. If you will be routing the cable through a hole in the transom, drill a 5/8"

diameter hole above the waterline. Route the cable through this hole,
then fill the hole with marine-grade silicone sealant and proceed to the
next step immediately.

Place the escutcheon plate over the cable hole and use it as a guide to
mark the two escutcheon plate mounting holes. Remove the plate, drill
two 9/64" diameter x 5/8" deep holes, and then fill both holes with
marine-grade silicone sealant. Place the escutcheon plate over the cable
hole and attach with two #8 x 5/8" wood screws.

Route and secure the cable by attaching the cable clamp to the transom;
drill one 9/64" diameter x 5/8" deep hole, then fill the hole with marine-
grade silicone sealant, then attach the cable clamp using a #8 x 5/8"
screw.

5. Plug the other end of the transducer cable back into the control head

connection holder.

NOTE:

If there is excess cable that needs to be gathered at one location

(as shown in the illustration), dress the cable routed from both directions
so that a single loop is left extending from the storage location. Doubling
the cable up from this point, form the cable into a coil. Storing excess
cable using this method can reduce electronic interference.

Storing Excess Cable

Routing the Cable