Humidex
14
Attaching the Flex and Outside Vent
From the outside, pull the flex pipe through the 6 ¼”
hole. Attach the vent to the 6” flex with the ½ in screws
provided.
Insert four 2 inch screws to secure the vent to the outside
wall. Make sure the vent is not twisted by inserting the
screws too tight and that the flaps are working properly.
NOTE:
If high winds are often present in the location of the vent, they may cause a wind
noise inside the house. If this is the case, an
anti-gust hood
(AGH-990) is available from
your Humidex dealer.
Wiring and Attaching the Control
Once the exhaust unit has been mounted, the control needs to be installed and connected. It
is crucial that the control is placed in the proper location. The HCS control must be installed
on the main floor and as close to the source of the replenishment air as possible while trying
to stay away from exterior doors and windows.
After having selected the installation location, the provided wire must be run from the main
unit to the control location.
